Linkage Parts:
Your operation depends on keeping your 3-point linkage system up and running. To help you do so, here are a few basic maintenance reminders:

• it's impossible to underestimate the importance of lubrication. Grease rear end linkage fittings on a regular basis - approximately once every 25 hours of operation
• whenever you hook up equipment to the drawbar, make sure that the PTO driveline is as straight as possible. This will prevent excess wear.
• For safety reasons, be sure the draft/position selector lever is in position control when you hook up implements.

1. Inflate tires to correct pressure and lower tractor to ground
2. Refill fuel tank(s)
3. Check radiator coolant levels
4. Check oil levels
5. Install fully-charged batteries
6. Remove exhaust pipe covering
7. Prime engine oil system
   1. Remove fuel solenoid relay /disconnect fuel solenoid
   2. Crank engine for 20 seconds/ Wait one minute. Repeat procedure 2 or more times.
      IMPORTANT: Priming engine oil provides lubrication to the turbo-charger and engine before starting which will extend engine life
   3. Re-install the fuel solenoid relay/reconnect fuel solenoid
8. Start engine & check that all instruments and controls function properly. Using tractor hydraulic system in Position Control, fully raise the left linkage and remove the supports
9. Drive the tractor without a load to ensure that it is operating satisfactory If you encounter any problems while performing the above checklist, please contact Robert's Farm Equipment Sales Inc. at 519-363-3192.